E203.11 Slant Top
Year made- 2003, Revision No. 11, Number produced- 100 and numbered 1 through 100
Model E203.11 is a blade style head with an elongated cavity for heel toe weighting. The blade is different from the other models in that it is tapered from heel to toe in two directions. This design makes the toe taller and wider than the heel, as the the top line “slants” upward and the trailing edge “slants” backward. The Slant Top looks a bit more upright at address and the tapered trailing edge helps the player close the blade at impact. This blade was designed for the right handed player whose tendencies are to push putts to the right and is a time proven classic design.
The top line is a bit thinner on this model giving it a sleek look behind the ball. A shallow cavity ensures a solid thick face and the tapered heel and toe masses balance the head perfectly for unparalleled feel at impact.
As with all the models, edges in the cavity are machined parallel unlike cast putters that must incorporate small draft angles.
The overfit neck incorporates an extended internal post that provides a greater surface contact area between the shaft and neck. This improved connection between shaft and head,gives less vibration at impact, and super solid feel. The slender overfit style also gives a clean confidence building look at address.
The patented sighting system incorporates a positive raised center line, with recessed dual outside lines for sure alignment under any lighting conditions. No matter the position of the sun, the raised center line casts a small helpful shadow for alignment aid.
Offset is 1/2 shaft and the neck is positioned slightly more towards the center of this model giving it a hanging angle of 32 degrees. Loft is set at 3 degrees. Each head is machined from a single solid block of carbon steel which starts with a weight of approximately 11 pounds. This technique ensures continuous metallurgical grain flow throughout the head and neck and consistent harmonics from putter to putter. The heads are then plated with a glare and corrosion resistant nickel finish.
SPECIFICATION
E203.11 Slant Top Putter Specifications |
|
Back Design Style |
Slanted Blade, Swept Cavity Back Style |
Head Material |
One Piece Carbon Steel |
Finish |
Satin Nickel (low glare/non rust) |
Neck/Hosel Type |
Long Tang Overfit |
Sight Line |
Raised Center, Double Outside |
Head Hanging Angle |
56 degrees |
Head Weight |
340grams, +/- 2 |
Loft |
3 degrees |
Lie |
71 degrees |
Offset |
1/2 Shaft, (0.185 in. ) |
Shaft |
True Temper, stepped, 0.370 tip |
Grip |
Lamkin, deep etched paddle |
Standard Length |
34 in. |
Face |
Outlined, Cross Milled Hitting Area |
FOLLOW US
Plus 2 International, Inc.
2790 Loker Ave. West, Unit 104
Carlsbad, CA 92010