Jack Nicklaus Special Edition A205.5 CLASSIC


Year made- 2003, Revision No. 11, Number produced- 25 and numbered 1 through 25

These special satin and dark nickel finished carbon steel A205.5 putters were designed for Jack Nicklaus' personal use. Built around the A205.5 Classic head, these putters were made in a range of weights from 325 to 340 grams for Jack's personal experimentation.

Serving as Jack's club designer, I always make a small number of each of my new putter designs to his specs, for his personal inspection and possible use. The remainder of each group, not in his possession, are what you see here.

Together with the Special Edition head cover these rare putters make a limited edition's, limited edition. A very small number of putters made for the greatest player of all time.

Model A205.5 is classic heel toe weighted blade style head. The toe and heel have symmetric angles on this model, while the single step and swept heel and toe masses provide balance. As with all the models, edges in the cavity are machined parallel unlike cast putter that must incorporate small draft angles.

Each putter is machined from a single solid block of carbon steel which starts with a weight of approximately 11 pounds. This technique ensures continuous metallurgical grain flow throughout the head and neck and consistent harmonics from putter to putter.

The patented Long Barrel Straight Slant Neck provides improved feel by making a better connection between shaft and head, while giving a clean look at address. The extended socket provides a deeper shaft insertion, less vibration at impact, and super solid feel.

The patented sighting system incorporates a positive raised center line, with recessed dual outside lines for sure alignment under any lighting conditions. No matter the position of the sun, the raised center line casts a small helpful shadow for alignment aid.

Offset is full shaft and the neck is positioned more into the heel of this model giving it a hanging angle of 36 degrees. Loft is set at 4 degrees. Models are machined from a single piece of soft carbon steel and satin nickel plated with a glare and corrosion resistant finish.




A205.5 Classic JNSE Putter Specifications

Back Design Style Heel Toe, Classic Cavity Back Style
Head Material One Piece Mild Carbon Steel
Finish Satin Nickel & Dark Nickel (low glare/non rust)
Neck/Hosel Type Long Barrel Straight Slant
Sight Line Raised Center, Double Outside
Head Hanging Angle 36 degrees
Head Weight 340grams, +/- 2
Loft 4 degrees
Lie 71 degrees
Offset Full Shaft, (0.185 in. )
Shaft True Temper, Fluted, 0.370 tip
Grip Lamkin, deep etched paddle
Standard Length 35 in.
Face Outlined, Cross Milled Hitting Area
Legal notice | Privacy policy
Design and studio photography by Plus 2 International, Inc.
Selected product photography by Jeff Lucero and Camada Sports
Copyright 2003, Plus 2 International, Inc. All rights reserved.