E203.11 Slant Top
 

ART AND BALANCE

Year made- 2003, Revision No. 11, Number produced- 100 and numbered 1 through 100

Model E203.11 is blade style head with an elongated cavity for heel toe weighting. The blade is different from the other models in that it is tapered from heel to toe in two directions. This design makes the toe taller and wider than the heel, as the the top line "slants" upward and the trailing edge "slants" backward. The Slant Top looks a bit more upright at address and the tapered trailing edge helps the player close the bade at impact. This blade was designed for the right handed player whose tendencies are to push putts to the right and is a time proven classic design.

The top line is a bit thinner on this model giving it a sleek look behind the ball. A shallow cavity insures a solid thick face and the tapered heel and toe masses balance the head perfectly for unparallel feel at impact.

As with all the models, edges in the cavity are machined parallel unlike cast putters that must incorporate small draft angles.

The overfit neck incorporates an extended internal post that provides a greater surface contact area between the shaft and neck. This improved connection between shaft and head,gives less vibration at impact, and super solid feel. The slender overfit style also gives a clean confidence building look at address.

The patented sighting system incorporates a positive raised center line, with recessed dual outside lines for sure alignment under any lighting conditions. No matter the position of the sun, the raised center line casts a small helpful shadow for alignment aid.

Offset is 1/2 shaft and the neck is positioned slightly more towards the center of this model giving it a hanging angle of 32 degrees. Loft is set at 3 degrees. Each head is machined from a single solid block of carbon steel which starts with a weight of approximately 11 pounds. This technique ensures continuous metallurgical grain flow throughout the head and neck and consistent harmonics from putter to putter. The heads are then plated with a glare and corrosion resistant nickel finish.




 
HEAD COVERS
SHAFT BANDS
GRIPS
   
   

E203.11 Slant Top Putter Specifications

Back Design Style Slanted Blade, Swept Cavity Back Style
Head Material One Piece Carbon Steel
Finish Satin Nickel (low glare/non rust)
Neck/Hosel Type Long Tang Overfit
Sight Line Raised Center, Double Outside
Head Hanging Angle 56 degrees
Head Weight 340grams, +/- 2
Loft 3 degrees
Lie 71 degrees
Offset 1/2 Shaft, (0.185 in. )
Shaft True Temper, stepped, 0.370 tip
Grip Lamkin, deep etched paddle
Standard Length 35 in.
Face Outlined, Cross Milled Hitting Area
Legal notice | Privacy policy
Design and studio photography by Plus 2 International, Inc.
Selected product photography by Jeff Lucero and Camada Sports
Copyright 2003, Plus 2 International, Inc. All rights reserved.